Ford transmission control module9/27/2023 ![]() ![]() ![]() If you need to manually reset your TCM, the process is fairly simple. After all steps have been completed, reattach negative battery cable so that power can be restored to your vehicle and its systems once again.Step 4: Reconnect Negative Battery Cable when Finished Resetting TCM Depending on your car’s make and model, this could involve removing a few bolts as well as unhooking some harness connectors that may be attached to it.Step 3: Remove TCM Cover or Harness Connectors This is done in order to protect both you and your car while resetting the module.Step 2: Disconnect Negative Battery Cable from Vehicle’s Battery Most transmission control modules are located under the hood of your car, usually close to the firewall on the driver’s side of the vehicle.Step 1: Locate the Transmission Control Module.Finally, test out whether or not your issue has been resolved by driving around if all goes well, then you can consider yourself successful! After you’ve done this, turn on your car and allow it run for a few minutes before turning if off again. Then disconnect any other connections connected to the TCM and wait at least 30 seconds before reconnecting everything again. To do this, you’ll need to locate the fuse for the TCM in your vehicle’s fuse box and remove it from its slot. If your car has been exhibiting strange behavior, such as jerky movements or an inability to shift smoothly, it may be time to reset the TCM. The transmission control module (TCM) is a device that controls various aspects of an vehicle’s automatic transmission.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |